Operation Manual

Notice:
Please make sure that the correct depth is
set for the saw blade depending on the
material (☞ Operating instructions– Page
22).
– Open the lock on the cutting depth limiter (5).
– Set the cutting depth limiter (5) on the desired
cutting depth.
– Close the lock on the cutting depth limiter (5).
Turning the device on/off
WARNING
Risk of injury!
Before cutting, wait until the blade has
reached its maximum speed.
Notice:
Thedeviceisttedwithanoverload
protection. If the indicator light (11) starts to
 ash,reducethefeedforcewithwhichyou
push the device through the work piece.
If the indicator light (11) lights up
continuously and the device has stopped,
the overload protection has switched the
device off. Either the feed force was too
high or the saw blade was blocked by a
foreign body in the work piece. In both
cases, turn the device off and check the
work piece for foreign bodies and the saw
blade for damage.
 Ifyoudonotndanyforeignbodyinthe
work piece, you may resume your work at
reduced feed force.
– slide the On/Off switch (12) backwards.
Notice:
For a better handling of the device, a press
button is integrated to the On/Off switch (12).
Turn the device on and press the button.
– Release the On/Off switch (12).
Assemble/set up the parallel limit stop
Notice:
The parallel limit stop can be used for
precise cutting of the work piece.
The parallel limit stop can be assembled
on the device from both sides. The length
  specicationontheparallellimitstopis
only an approximate dimension.
– Loosenxingscrews(3).
– Guide the parallel limit stop (18) through the
opening guides (4).
21
EN