SDS

Tub Refinishing Inc., DBA Munro Products Page 3 of 7
violent rupture of the container. Combustion may produce carbon monoxide, carbon
dioxide and irritating or toxic vapors and gases.
5.3 Flash Point:
89° F (32 ° C).
5.4 Special protective actions
for fire-fighters:
Wear self-contained breathing apparatus (SCBA) and full fire-fighting protective
clothing. Thoroughly decontaminate all protective equipment after use.
Evacuate all persons from the fire area to an explosion-protected location. Move
non-burning material, as feasible, to a safe location as soon as possible. Fire fighters
should be protected from potential explosion hazard while extinguishing the blaze.
Containers of this material may build up pressure if exposed to heat (fire). Use water
spray to cool fire-exposed containers. DO NOT extinguish a fire resulting from a
large flow of this flammable liquid until the flow of liquid is effectively shut off.
This precaution will help prevent the accumulation of an explosive vapor-air mixture
after the initial fire is extinguished. Use water spray to disperse vapors if a spill or
leak has not ignited. See Section 13 for disposal considerations.
6. Accidental Release
6.1 Personal precautions,
protective equipment and
emergency procedures:
Remove all sources of ignition (flares, flames including pilot lights, electrical
sparks). NO SMOKING. Persons not wearing protective equipment (see Section
8) should be excluded from the area of the spill until clean-up has been
completed.
6.2 Methods and materials for containment and clean up:
For Small Spills:
Absorb spill with inert material (e.g., dry sand or earth), then place in a
chemical waste container. Use non-sparking (non-metallic) tools to clean up
spill.
For Large Spills
(drums or larger):
Stop spill at source. Prevent spilled material from contaminating soil or entering
drains, sewers, streams or other bodies of water. Prevent spilled material from
spreading. Immediately notify authorities of any reportable spill as may be
required pursuant to regulations. See Section 15 for applicable CERCLA
reportable quantities. Scrape or pump spilled product to clean containers for
recovery. Absorb unrecoverable product. Transfer contaminated absorbent, soil
and other waste materials to waste containers for disposal.
7. Handling & Storage
7.1 Precautions for safe handling:
Avoid inhalation and contact with eyes, skin, and clothing. Wash hands
thoroughly after handling and before eating or drinking. Remove and wash
contaminated clothing before reuse. Use with adequate ventilation. Ground
and bond containers when transferring the material to prevent static
electricity sparks which could ignite the vapor. Use spark-proof tools and
explosion-proof equipment. Consult your supplier of promoters and catalysts
for additional instructions on proper mixing and usage. Empty containers
may retain product residue (liquid and/or vapor). Do not pressurize, cut,
weld, braze, solder, drill, grind, or expose these containers to heat, flame,
sparks, static electricity, or other sources of ignition as the container may
explode and may cause injury or death. Empty drums should be completely
drained and properly bunged. Empty drums should be promptly returned to a
drum reconditioner or properly disposed.
7.2 Conditions for safe storage,
including any incompatibilities:
Keep away from ignition sources: flames, pilot lights, electrical sparks, and
sparking tools. NO SMOKING. Do not store in direct sunlight. Store
separate from oxidizing materials, peroxides, and metal salts. Keep container
closed when not in use. To ensure maximum stability and maintain optimum
resin properties, resins should be stored in closed containers at temperatures
below 75°F (25°C). Copper or copper containing alloys should be avoided as
containers.