SDS

Tub Refinishing Inc., DBA Munro Products Page 6 of 13
protective equipment. Reference should be made to appropriate monitoring
standards. Reference to national guidance documents for methods for the
determination of hazardous substances will also be required.
Appropriate
engineering controls
Use only with adequate ventilation. Use process enclosures, local exhaust ventilation
or other engineering controls to keep worker exposure to airborne contaminants
below any recommended or statutory limits. The engineering controls also need to
keep gas, vapor or dust concentrations below any lower explosive limits. Use
explosion-proof ventilation equipment.
Environmental
exposure controls
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
8.2 Individual protection measures
Hygiene measures
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Eye/face protection
Chemical splash goggles.
8.3 Skin protection
Hand protection
Chemical-resistant, impervious gloves complying with an approved standard should
be worn at all times when handling chemical products if a risk assessment indicates
this is necessary. Considering the parameters specified by the glove manufacturer,
check during use that the gloves are still retaining their protective properties. It
should be noted that the time to breakthrough for any glove material may be
different for different glove manufacturers. In the case of mixtures, consisting of
several substances, the protection time of the gloves cannot be accurately estimated.
Gloves
For prolonged or repeated handling, use the following type of gloves:
May be used: nitrile rubber
Recommended: butyl rubber, polyvinyl alcohol (PVA), Viton®
Body protection
Personal protective equipment for the body should be selected based on the task
being performed and the risks involved and should be approved by a specialist
before handling this product. When there is a risk of ignition from static electricity,
wear antistatic protective clothing. For the greatest protection from static discharges,
clothing should include anti-static overalls, boots and gloves.
Other skin protection
Appropriate footwear and any additional skin protection measures should be
selected based on the task being performed and the risks involved and should be
approved by a specialist before handling this product.
8.4 Respiratory protection
Respirator selection must be based on known or anticipated exposure levels, the
hazards of the product and the safe working limits of the selected respirator. If
workers are exposed to concentrations above the exposure limit, they must use
appropriate, certified respirators. Use a properly fitted, air-purifying or air-fed
respirator complying with an approved standard if a risk assessment indicates this is
necessary. United
9. Physical & Chemical Properties
9.1 Physical state
Liquid
9.2 Color
Varies
9.3 Odor
Not available.
9.4 Odor threshold
Not available.
9.5 pH
Not available.
9.6 Melting point
Not available.
9.7 Boiling point
38°C (100.4°F)
9.8 Flash point
Closed cup: 23.33°C (74°F)
9.9 Auto-ignition temperature
Not available.