How to Guide
CHIP REPAIR INSTRUCTION MANUAL
Tub, Tile, Wall Surround, & Sink Repair Kit
A. Chip Repair Application
Step 1: Pick or Dremal away loose matter and tapper the edges
with a sharp-edged utility knife.
Step 2: Mix three (3) parts Chip Filler with (1) part Cream
Hardener. Stir mixture thoroughly with applicator stick. Patch
must be used within two (2) minutes. *ONLY MIX what’s
needed. The remaining unmixed products can be saved for
later use.
Step 3: Liberally apply patch compound to repair area with stir
stick or Razor blade. Patch will not respond to surface below
65F. Using a heat gun or hair dryer will speed dry time
considerably.
Step 4: Once patch has completed its cure, the patch will be
hard to the touch. After the patch has cured, sand area dry or
wet with 120 grit sandpaper until ush with surrounding area.
Repeat step 2 & 3 if necessary.
B.
Repair Paint Application
Step 1: Wipe the repair and surrounding area clean using the
alcohol preps provided.
Step 2: Shake Repair Paint thoroughly. Carefully unscrew
repair paint brush cap.
Step 3: Dip Brush into Repair Paint. Lightly stroke repair.
Lightly feather edges. MUST DRY 24 HOURS BEFORE
USE!
Visit www.Bath-Works.net for the Touch-Up Paint Kits and
other bathtub care products.