Installation Instructions
D
DOOR SENSOR
The Puck has an integrated hall-effect sensor that uses a magnet to determine if the door is open
or closed. The magnet must be installed so it is within ~ΒΌ inch of the sensor inside Puck when the
door is closed (refer to slide 2 for the sensor location.)
To assist in setup, the Puck will chirp any
time it detects the door opening or closing. This will
allow you to easily determine if the magnet i
s properly aligned with the sensor.
Vault Mounting
For mounting in a vault, the adjustable mounting
base can be used. This allows the magnet to be
fine
ly adjusted to the correct position.
Door Mounting
For mounting to a door, the magnet can be pushed out to
r
remove it from the adjustable base. The smaller magnet
holder can now be mounted to a door frame.
Magnet is mounted on side wall
of vault to align with the Puck
Battenfeld Technologies Inc.