Operating Guide

ManualsBrandsBattery Tender ManualsAutomotiveAGM Power Station 1200-Amp Car Battery Jump Starter





1200Amp VEHICLE JUMP STARTER

PORTABLE POWER STATION

P/N 030-0006

Instruction Manual

DO NOT EXPOSE TO WATER, FIRE, OR SMOKE

CHARGE UNIT BEFORE USE,

AFTER EACH USE AND EVERY 3 MONTHS!

Manual P/N 390-1023-R0

2



Important: Please ensure that you read and save this instruction manual

before using this product. Incorrect operation or misuse of this Jump

Starter may damage the equipment or create hazardous conditions for the

user. SAVE THESE SAFETY INSTRUCTIONS FOR FUTURE USE.

! WARNING

Warnings identify conditions that could result in personal injury or loss of

life

! CAUTION

Cautions identify conditions or practices that could result in damage to the

unit or to other equipment.

NOTE:

Describes an important action item or an item requires attention.

Abbreviations and Acronyms

A Ampere

AC Alternating current

Ah Amp hours

DC Direct current

mA Milliamps

V Volts

LED Light emitting diode

WH Watt Hours

Summary of content (7 pages)

PAGE 1
Important: Please ensure that you read and save this instruction manual before using this product. Incorrect operation or misuse of this Jump Starter may damage the equipment or create hazardous conditions for the user. SAVE THESE SAFETY INSTRUCTIONS FOR FUTURE USE.
PAGE 2
CONTENTS 1. Introduction Introduction…………………………………………………………………………. 4 Easy to operate and designed for reliable service. The Jump starter can: Important Safety Instructions……………………………………………………. 4 * Jump start cars, light trucks, motorcycles, ATV’s, lawn tractors and more. Features……………………………………………………………………………… 6 Operating Instructions……………………………………………..……………... 8 Recharging the Jump Starter internal battery……………..…………………. 9 12V DC Outlet (Power Port) ..………..…………………………………………. 10 Maintenance and Care...
PAGE 3
! 3. WARNING Features Never allow the red and black clamps to touch each other or another common metal conductor. This could cause damage to the Jump Starter and possibly create a spark or even explosion hazard. ! WARNING For a negative-grounded vehicle, first connect POSITIVE (RED) clamp to the POSITIVE (RED +) ungrounded battery post. Then connect NEGATIVE (BLACK) clamp to the vehicle chassis or engine block away from the battery.
PAGE 4
6) AC charging jack – Use the included AC charger to recharge the internal battery through this charging jack. Only use the supplied AC charger to charge the Jump Starter. 7) Charging Status indicator – Red LED indicates when the Jump Starter is being recharged. When the LED turns Green the Jump Starter is fully charged. 8) 120VAC/60Hz/100Watt Outlet – Use this for powering a variety of 120V accessories. 9) 120VAC Power LED – This indicates there is power to the 120VAC outlet.
PAGE 5
) 6) ! Turn the power switch on. Before attempting to start the engine, make sure that the Jump Starter and the battery clamp cables are clear of any metal parts and any moving parts in or around the engine compartment. ! Start the engine for 3 seconds or until the engine starts, whichever comes first. Do not crank the engine for longer than 3 seconds. See the following warning. ! WARNING: Fire Hazard The Jump Starter must not be recharged through the 12V DC socket.
PAGE 6
BATTERY MAINTENANCE The Jump Starter internal battery should be recharged periodically. The manufacturer recommends at least once every 3 months when the Jump Starter is not being used for extended periods of time. This is especially true in warm environments. It is also a very good idea to recharge the internal battery soon after using it to restart an engine. 8.
PAGE 7
9. Specifications 1200Amp Internal battery (Capacity/Type) 20Ah (AGM) sealed lead acid 1200Amp Jump Start cable (Size/Length) 6AWG / 18ʺ AC Adapter 15V DC@800mA 12VDC Power Port maximum current 15A 12V DC Power Port Fuse Bussman ATM-15, 32V 15A or equivalent fuse 110VAC 60Hz Plug 100 Watts Maximum output Dimensions L x W x H 11½ x 7½ x 9½ Operating temperature gauge 0°C - 40°C (32°-104°F) 10.