User's Manual

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This

equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures: – Reorient or relocate the

receiving antenna. – Increase the separation between the equipment and receiver. –

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected. – Consult the dealer or an experienced radio/TV technician for help.

CAUTION:

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference and (2) This device

must accept any interference received, including interference that may cause undesired

operation.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment.

This equipment must not be co-located or operating in conjunction with any other antenna

or transmitter.

Max. SAR Measurement (1g)

802.11b: 0.739 W/kg