GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: docs.bauknecht.eu YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• Children must be supervised to ensure they do not play with the appliance. • When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes. • The ventilation ducts must always discharge to the outside. • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed.
Declaration of conformity • This appliance has been designed, manufactured and marketed in compliance with: - safety objectives of the “Low Voltage” Directive 2014/35/EU; - the ecodesign requirements of european regulations n. 65/2014, and n. 66/2014 in conformity to the european standard EN 61591 - the protection requirements of Directive “EMC” 2014/30/EU. Electrical safety of the appliance can only be guaranteed if it is correctly connected to an approved earthing system.
FILTERING OR DUCTING? ! Your cooker hood is ready to be used in suction version. To use the hood in filtering version the special ACCESSORY KIT must be installed. Check on the first pages of this manual if the ACCESSORY KIT is furnished or must be bought separately. Note: If furnished, in certain cases, the additional activated carbon filtering system may be installed on the hood. Information about the conversion of the hood from suction version to filtering version is present in this manual.
TROUBLESHOOTING GUIDE The appliance does not work: • Check for the presence of mains electrical power and if the appliance is connected to the electrical supply; • Turn off the appliance and restart it to see if the fault persists. The hood's suction level is not sufficient: • Check the suction speed and adjust as necessary; • Check that the filters are clean; • Check the air vents for any obstructions.
T5. Button to select ‘silent’ suction speed (power) and saturation indicator for grease filter. Note: when flashing, perform maintenance of the grease filter; then keep the button T1 pressed for a long time to stop the flashing. T6. Button ON/OFF lighting T2+T3+T4 flashing: automatic operation under high temperature conditions (see relevant paragraph). Activation of the charcoal filter saturation indicator This indicator is normally deactivated.
Disassembly Remove the charcoal filter by turning the knobs fixing it to the hood by 90°. Replacing lamps The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy. For replacement, contact the technical service. TECHNICAL DATA Model Height (cm) Width (cm) Depth (cm) Ø of exhaust tube (cm) DBHC 62 LT X 66.5– 109 75 –115 59.8 50.5 15-12.
20
12 14 13
15a 15b
16 17 18
07/2016 400010911373 GB Bauknecht® Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2015. All rights reserved - http://www.bauknecht.
