GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: docs.bauknecht.eu YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes. • The ventilation ducts must always discharge to the outside. • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type. Use the correct length for the screws which are identified in the Installation Guide. In case of doubt, consult an authorised service assistance centre or similar qualified person.
AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". 2. Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service.
MAINTENANCE Cleaning Clean using ONLY the cloth dampened with neutral liquid detergent. DO NOT CLEAN WITH TOOLS OR INSTRUMENTS. Do not use abrasive products. DO NOT USE ALCOHOL! Perimeter aspiration panel Clean the perimeter aspiration panel with the same frequency as the ant-fats filter, using a cloth and not too concentrated liquid detergent. Do not use abrasive substances. Maintenance of the anti-grease filters Traps cooking grease particles.
TECHNICAL DATA Model Height (cm) DBIBS 92 LT X 62.4 -102.3 75.3 - 102.3 Width (cm) Depth (cm) Ø of exhaust tube (cm) 89.8 60.6 15-12.5-12 Please check the plate in order to verify the total absorption and the light absorption. The hood is equipped with a lighting system based on LED technology. For replacement, contact the technical service.
1x x2 44x Ø 3,5x9,5 2x 6x 14x Ø M4x7 4x 3x9 Ø 10x70 1x 6x x1 x1 Ø 6x70 1x 14x 1x x2 1x 6x Ø 3,5x9,5 Ø 120 mm Ø 125 mm Ø 150 mm 1x 1x 2x 2x 1x
R1 SX R1 FRONT SX 1 RX 220-240 V ~ 50-60 Hz SX FRONT 3 2 6 5 4 RX 6 x Ø 10mm FRONT RX R2 4x Ø 10x70 mm RX SX FRONT 4x Ø 6x70mm 2 1 FRONT SX 1cm RX x2 FRONT x1 SX Ø 16cm RX 4 3 min 74 cm 76 cm L min max 103cm ³ 65 cm ³ 50 cm 5 H(cm) = L - 22,4 H
16 x Ø 3,5x9,5mm SX FRONT RX H - 7cm 6 7 ! 8 9 10 11
1x Ø 3,5x9,5 12 16 x Ø 3,5x9,5mm 13 14 x4 x1 15 16
6x Ø 3,5x9,5mm = = 17 x4 8x Ø 3,5x9,5mm 18 19 x8 x4
220-240 V ~ 50-60 Hz 8x Ø M4x7mm 21 20 x6 2x Ø 3x9mm 22 23 6x Ø M4x7mm 24 25 x6
26 27 2x Ø 3x9mm 28 30 29
X 31 32 X
GB 08/2016 400010915611 Bauknecht® Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2015. All rights reserved - docs.bauknecht.