Operation Manual

21
INSTALLATION
•
Install the freezer away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near
heat sources (heaters, radiators, cookers) will increase power
consumption and should therefore be avoided.
•
If this is not possible, the following minimum distances must
be respected:
•
30 cm from coal or paraffin stoves;
•
3 cm from electric and/or gas stoves.
•
Install the appliance in a dry, well-ventilated place.
•
Clean the inside (see “How to defrost and clean the freezer”).
•
Fit the accessories supplied (Fig.
1
and
2
).
Electrical connection
• Electrical connections must be made in accordance
with local regulations.
•
Voltage and power consumption are indicated on the rating
plate inside the appliance.
•
Regulations require that the
appliance is earthed.
The Manufacturer declines all liabilities for injury to
persons or animals or damage to property resulting
from failure to observe these regulations.
•
If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
•
Do not use extension leads or adapters.
Disconnecting the appliance
Electrical disconnection must be possible either by unplugging
the appliance or by means of a double-pole switch located upline
from the socket.
Fig. 1
Fig. 2
40302002GB.fm Page 21 Tuesday, March 27, 2007 10:22 AM