Instruction for Use

4
FIRST TIME USE
After connecting the appliance to the power supply, the device must be programmed. The display will guide the user to set up the appliance for first use.
1. The language selection
2. Setting the water hardness
3. Filling the salt reservoir
ENGLISH?
P =NO, fflst =YES
To select preferred language please press button. Confirm pressing button.
After language confirmation, the appliance will go through the settings.
WATER HARDNESS
<1=Min, 7=Max>
The water hardness is by default set to level
4. To change water hardness level press
button repeatedly.
To confirm your choice press button.
The level must be set according to the table
below.
Detergents
When using Powder or Gel you must add
regeneration salt and set up water hardness
level as indicated in the table below.
WATER HARD.= 4
P =NO, fflst =YES
Also, when using Tablets which include salt
functionality you must still add regeneration
salt.
1. Ask your water supply company what the water hardness is... 2. ... enter this value on your dishwasher
SALT required
German
degrees °dH
French
degrees °fH
English
degrees °eH
Water hardness level Insert value is shown in the display
0 - 5 0 - 9 0 - 6.3 Soft 1NO
6 - 10 10 - 18 7 - 12.6 Medium 2
YES
11 - 15 19 - 27 13.3 - 18.9 Average 3
16 - 21 28 - 37 19.6 - 25.9 Medium-hard 4
22 - 28 38 - 50 26.6 - 35 Hard 5
29 - 35 51 - 63 35.7 - 44.1 Very hard 6
36 - 50 64 - 90 44.8 - 62.4 Extremely hard 7
POUR WATER
OPERATION
When water hardness is set, it is required to fill salt reservoir with water and special regeneration salt.
As a first step it is needed to fill reservoir with 1.5 litres of fresh water.
Confirm operation by pressing button.
INSERT 1,5L OF
fflst = DONE
WATER IN THE
fflst = DONE
SALT RESERVOIR
fflst = DONE
INSERT SALT
OPERATION
ADD 1KG OF
fflst = DONE
SALT IN THE
fflst = DONE
SALT RESERVOIR
fflst = DONE
Unscrew cap.
Fill the salt reservoir with water.
Add 1kg of special regeneration salt dedicated only
for dishwashers. Other kind of salt cannot be used.
Screw on the cap.
Salt residue around the cap needs to be removed. Residual saline solution or
grains of salt can lead to deep-down corrosion, irreparably damaging the
stainless steel components.