Operation Manual

17
Open the door and turn on the water tap.
1.
Press the
I button (ON)
to switch on the
appliance. One of the programme indicator
lamps will illuminate.
2. Press the programme selector button
until the corresponding indicator lamp
illuminates.
If required,
select any additional functions
.
3.
Press the
Start
button to start the selected
wash programme. The Start indicator lamp will
illuminate.
Once set, the programmed data
cannot be altered by pressing the buttons or
programme selector button. Close the door.
Note:
Once the
Start
button has been pressed,
the dishwasher memorises all the programmes
selected. The selected programmes are also
saved in the event of power failure.
4.
To change the programme selected, open
the door
(beware of hot steam!)
and press
the
Start
button for about 5 seconds until the
Start
indicator lamp switches off. Select a
new programme using the
programme
selector button
, press the
Start
button, and
close the door.
5.
At the end of the programme an acoustic
signal sounds 4 times and the
Start
.
6.
Press the
0 button (OFF)
to switch off the
dishwasher (only after the End indicator lamp
has switched on or the Start indicator lamp
has switched off. All the indicator lamps
switch off.
Note:
If the dishwasher is switched off
during a wash programme
, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
HOW TO USE THE DISHWASHER
1
2
3
4
5
6
94004-gb.fm5 Page 17 Thursday, September 13, 2001 4:22 PM