Operation Manual
20
Before cleaning or carrying out maintenance,
press the ON/OFF button.
1.
Clean the appliance exterior with a neutral
detergent. Do not use abrasive detergents.
2.
Regularly wipe the door seal and inside of the
door with a damp cloth to remove any food
residues.
If the spray nozzles become clogged with
food residues,
clean the spray arms as follows:
Upper spray arm:
•
Slacken the fixing nut by turning it counter-
clockwise
A
and detach the spray arm by
pulling it down
B
.
•
Rinse the nozzles.
•
Remount the spray arm by aligning it with the
rotary mounting and insert it.
•
Tighten the fixing nut by turning it clockwise.
Make sure the nut is fully tightened (it should
click).
Make sure the spray arm rotates freely.
Lower spray arm:
•
Press the two levers inwards which fix the
spray arm
A
and detach by pulling it up
B
.
•
Rinse the nozzles.
•
Remount the spray arm by aligning it with the
rotor pin and insert it.
•
Push the spray arm down until it is fixed in
place.
•
Make sure the two levers are correctly
inserted (they should click).
Make sure the spray arm rotates freely.
Cleaning the filters
1.
Fully unscrew the wide-mesh central filter by
turning it counter-clockwise and extract it
A
.
2.
Fully unscrew the cylindrical filter and extract
it from the wide-mesh central filter
B
(pay due
attention to the holes in the bottom of the
filter).
3.
Remove the fine-mesh filter
C
.
4.
Clean all the components.
5.
Reassemble:
Insert the cylindrical filter in the wide-mesh
central filter. Fit the fine-mesh filter and
screw down the filter unit by turning it
clockwise. The filter unit must be correctly
assembled to ensure good washing results.
MAINTENANCE AND CLEANING
BA
A
B
A
B
C
94004-gb.fm5 Page 20 Thursday, September 13, 2001 4:22 PM