Operation Manual

11
Before using the dishwasher/Connections
1. Removing the packaging
and controls:
After unpacking, make sure
that the dishwasher is
undamaged and that the door
closes correctly. If in doubt,
contact a qualified technician
or your local retailer.
•
Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, as they are
potentially dangerous.
2. Water and electrical
connections:
All water and electrical
connections must be carried
out by a qualified technician
in compliance with the
manufacturer's instructions
(refer to the enclosed
installation booklet) and
current local safety
regulations.
The appliance must only be
used in the household for
the prescribed uses.
Do not use the dishwasher if it
has been damaged in transit.
Consult your local retailer or
our After-Sales Service.
(Refer to the separate
installation instructions
booklet)
3. Water inlet and drain:
•
Observe any special
regulations issued by your
local Water Board.
Water supply pressure:
0.3 - 10 bar.
•
Make sure the inlet and drain
hoses are kink-free and are
not crushed.
•
If the hose length is not
sufficient, please contact
your local dealer or our
After-Sales Service.
•
The inlet hose must be
securely clamped to the
water tap to prevent leaks.
•
The inlet water temperature
varies according to the model
installed. Inlet hose marked
“25° C Max”: maximum
temperature 25° C.
All other models: maximum
temperature 60° C.
•
When installing the
appliance, make sure the
drain water discharges
correctly (if necessary,
remove the wire gauze from
the sink siphon).
•
Fix the drain hose to the
spigot with a clamp to
prevent it from coming off
during operation.
•
For appliances with water-
stop system only: If the water
connections are made
correctly, the water-stop
system safeguards your home
against damage caused by
flooding.
4. Electrical connection:
•
Closely adhere to local
Electricity Board regulations.
Voltage information is shown
on the rating plate mounted
inside the door on the right
hand side.
•
The appliance must be
earthed as prescribed by law.
•
Do not use extension leads or
multiple adapters.
•
Before carrying out
maintenance, disconnect the
mains plug.
•
The power cable must only be
replaced by authorized
personnel.
Warning for models
provided with LCD display:
The mains plug must be
positioned in an easily
accessible place.
• For Austria:
if the apparatus
is series connected to a fault
current switch, this must be
sensitive to the pulsating
current.