Quick Start Guide

BK/II/FD/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the
ON
button.
Large compartment
A:
With each wash cycle.
Small compartment
B:
For programmes with pre-wash only.
Mechanical indicator lamp
C
.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator lamp
D
.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
If necessary (and if provided) the corresponding indicator
lamp lights up.
The selected programme
is then memorised (even
in the event of power
failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
OFF
button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Open the door
Switch on the appliance
How to fill the
detergent dispenser
C
BA
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Select options
Press the START button
“Change programme”
Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
Turn on the water tap
close the dishwasher door
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks