User manual

ROLManual rev.092914
7
Power and Battery
Power Button
The Power Button is located on the left side of the device toward the back near the
bottom, just above a small round port for the power supply.
Power Indicator Light
Located on the lower left front of the device about an inch about two inches above the
headphone jack. The light glows steady green when the device is on and blinks when it
is in standby mode. It glows red when the device is off and is being charged, and glows
orange when the device is on and is being charged.
Power Up
Press the Power Button to power up the device. The start-up process is indicated by a
series of beeps and takes approximately 90 seconds. When the ROL is ready, you will
hear: “Main Menu: Scan and Read.”
Standby Mode
When using the device on battery power, after a customized period inactivity, the ROL
goes into standby mode to consume less power. By default, standby will begin after
five minutes of inactivity. To select a different length of time you want the device to stay
awake when idle, start at the Main Menu and scroll to and select Settings, and then
select “General Settings.” Next, scroll to and select “Time Until Standby.” Scroll
through the length of time options and select your preference.
A short series of tones indicates when the device is going into this mode, and then a
blinking power indicator light indicates that the device is on standby. Press the Power
Button to wake up the ROL and return it to the active mode.
It takes about 15 seconds for the ROL to “wake up.” After a series of beeps, the device
is ready to operate. It wakes up in the same spot where it was left off going into sleep
mode. To check which menu option you are in, press the Center Daisy Button. To
return to the Main Menu, press the Home Button.
Power Down
To safely power down the device, from the Main Menu, scroll to and select Settings.
Then scroll to and select System Settings. Finally, scroll to and select Shut Down.