Instruction manual AS19SS-A Studio Solari 60 cm Multifunction oven
ELECTRIC SINGLE OVENS USER AND INSTALLATION INSTRUCTIONS
For future reference please record the following information which be found on the Rating Plate and the date of purchase which can be found in the invoice: Model Number ……………………. Serial Number ……………………. Date of Purchase …………………….
CONTENTS General Information pages 3-4 Warning and Safety Instructions pages 5-6 Instructions for Use pages 7-19 Instructions for Installation pages 20-23 Maintenance pages 24-25 Technical Data page 26 Conditions of Guarantee pages 27-28 European directive on Waste Electrical and Electronic Equipment (WEEE) page 29
GENERAL INFORMATION Please read this booklet thoroughly before you use this appliance. It is important that you understand all the control functions before commencing to cook with your Baumatic appliance. Please remember the advice and warnings shown on page 5 which is headed ‘IMPORTANT – Warning and Safety Instructions’. This appliance is designed for domestic household use and can be built into a standard kitchen cabinet or housing unit.
The Warranty applies to Great Britain and Northern Ireland only. In the event that you require any After Sales Service or advice, please contact the Baumatic Service Department on telephone number – 0118 933 6911. Before using this appliance ensure that any protective packaging or coatings have been removed. To aid the protection of the environment, please sort the packing materials into different types and dispose of them in accordance with the local waste disposal laws.
IMPORTANT NOTE – WARNING AND SAFETY INSTRUCTIONS Warning: this appliance must be earthed. This appliance complies with all current European safety legislation, however Baumatic do wish to emphasise that compliance does not remove the fact that the appliance surfaces will become hot during use and retain heat after operation.
NOTE: This appliance must be correctly installed by a suitably qualified person, strictly in accordance with the manufacturer’s instructions. For electrical installations, NICEIC registration is recommended. Baumatic Ltd declines any responsibility for injury or damage to persons or property as a result of improper use or installation of this appliance. Please note that this appliance carries the CE mark for normal domestic use and is not suitable for the marine environment.
INSTRUCTIONS FOR USE These User Instructions should be retained for future reference and for use by a person who is perhaps unfamiliar with the appliance. The following models are covered by these instructions: AS19SS-A UK AS19SK.
CONTROL PANEL 8 TEMPERATURE DISPLAY TIMER DISPLAY COOKING FUNCTIONS
FUNCTION BUTTONS Decreases temperature Increases temperature ON/OFF and CHILDREN CARE Minute minder Cooking time End time - Minus setting + Plus setting Program setting Program setting OPERATION The timer flashes on the display when switched on for the first time and the oven cannot be operated; follow the "Setting the time" procedure to start it. SETTING THE TIME Press buttons and simultaneously and use buttons - and + to set the exact time. SWITCHING ON THE OVEN Press button .
END OF COOKING SEMIAUTOMATIC OPERATION For fixed-time cooking Switch on the oven; press button and set the end of cooking time, within the next 23h59m, 23h59m, with buttons - and +.
Cooking functions: OVEN LIGHT The internal oven light goes on. If no cooking mode is selected after 1 minute, PRH PREHEATING Step 1 - The grill and sole resistance, the radial fan and the oven light turn on. A circular moving symbol is shown on the temperature display. Preheating up to 210°C. When the temperature has been reached, a specific acoustic signal will be emitted. The temperature cannot be changed. Step 2 - The internal oven light goes on.
Cooking functions: PIZZA FUNCTION This kind of cooking is ideal for pizza and vegetable dishes. With this function, lower heating element, circular heating element and fan motor work at the same time. FAN OVEN MODE This provides even heating with the fan and allows different dishes to be cooked at the same time on different levels. DEFROST MODE The fan runs without heat to reduce the defrost time for frozen food. The message " dEF " is shown on the temperature display.
OTHER FUNCTIONS OVEN OFF MODE When no function is selected, the temperature and program displays are off and the timer displays the time. "CHILDREN CARE" - CONTROLS LOCK FUNCTION Hold down button for at least 3 seconds: the oven will be set on "children care" function; the display will show " " and then " On ". The time is then displayed again.
WARNING • • • Ensure that the oven door is kept closed when using the GRILL. Do not use aluminium foil to cover the grill pan or heat. Do not wrap items in aluminium foil and place under the grill – the high reflectivity of the foil can damage the grill element. HELPFUL HINTS • • • • • Before cooking, check that any unused accessories are removed from the oven. Preheat the oven at cooking temperature before use.
CLEANING THE APPLIANCE Always allow the appliance to cool down before cleaning to avoid a burn injury. Do not use caustic or abrasive agents, coarse wire wool or hard tools as these can damage the surface finishes. Normally, wiping with a soft cloth dampened with hot detergent is sufficient, but for stubborn marks the following is recommended: VITREOUS ENAMEL PARTS Use only a cleaner that is recommended for this type of material – avoid chloride-based products such as bleach.
REMOVING THE OVEN DOOR INNER GLASS PANEL (fig. 1-2) Do not use any abrasive medium that could cause damage. Remember that if the surface of the glass panel becomes scratched, this could lead to a dangerous failure. To remove the oven door inner glass panel, use a coin to perform a levering action in the two grooves (A) until the two pins (B) are released from their housing (fig. 1). Then raise the glass as shown in fig. 2 and take it out from the top.
REMOVING THE OVEN DOOR INNER GLASS PANEL (fig. 1-2) Fig. 1 Fig.
REMOVING AND REFITTING THE OVEN DOOR (1-6) The door can be hooked on both sides Block position 1 Release position 2 3 18
4 5 6 Release position Block position Warning: once completed the operation, check the door is correctly hooked.
INSTRUCTIONS FOR INSTALLATION This appliance must be installed by a competent person, in accordance with the current version of the following UK Regulations and Safety Standards or their European Norm replacements: Building Regulations (issued by the Department of Environment) Building Standards (issued by the Scottish Development Department) IEE Wiring Regulations Electricity at Work Regulations PRE-COMMISSIONING THE APPLIANCE When unpacked, check that the following parts are included with the appliance: •
INSTALLATION 85-90 85-90 550 min. 592-593 564 85-90 550 min.
25 12,9 4,6 Front panel (side view) Fixing screw Oven door (upper view) 597 560 525 520 25 575 591 22 Fixing screw (1 on each corner)
ELECTRICAL CONNECTION Before connecting the appliance, make sure the supply voltage marked on the Rating Plate corresponds with the mains supply voltage. WARNING – THIS APPLIANCE MUST BE EARTHED This appliance should be wired into a 16A double pole switched fused spur outlet having 3mm contact separation and placed in an easily accessible position adjacent to the appliance.
REPLACING THE MAINS LEAD In the event it is necessary to replace the mains supply lead, proceed as follows: 1. Disconnect the appliance from the supply, undo the fixing screws and remove the back panel. 2. Undo the clamp screws and terminal screws to release the existing lead. 3. Assemble the replacement lead that must conform to the specification listed in the Technical Data, ensuring the correct colour code connection and that all screws are tightened correctly.
REPLACING THE OVEN LIGHT (Not covered by the appliance warranty) Disconnect the appliance from the electricity supply, remove the oven door (as described previously) as well as the oven shelves. Remove the protective glass lightcover by twisting anti-clockwise. Unscrew the old bulb and discard safely, replace with the type specified in the Technical Data and refit the cover. NOTE – The glass cover may be tight and may therefore require a tight grip to release.
TECHNICAL DATA DIMENSIONS Height: Width: Depth: 591mm 597mm 525mm COOLING FAN A tangential cooling fan is fitted on the following models: AS19SS-A UK, AS19SK.X-A ELECTRICAL DETAILS Rated Voltage: 230V a.c. 50Hz Supply Connection: 16A (double pole switched fused outlet with 3mm contact gap) MAX RATED INPUTS: AS19SS-A UK, AS19SK.X-A 3,68kW Mains supply lead: 3x 1.
Baumatic Ltd. Conditions of guarantee Dear Customer, Your new Baumatic appliance comes complete with a free 12 month guarantee covering both parts and labour costs resulting from defective materials or workmanship. Baumatic also gives you the opportunity to automatically extend the guarantee period for a further 12 months at no extra cost, giving an initial guarantee period of 24 months. The extended guarantee period applies to England, Scotland, Wales and Northern Ireland only.
Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephone +44 118 933 6900 Sales Fax +44 118 931 0035 Service Telephone +44 118 933 6911 Service Fax +44 118 986 9124 Spares Telephone +44 118 933 6922 Technical / Advice Telephone +44 118 933 6933 E-mail: sales@baumatic.co.uk technical@baumatic.co.uk Http (Internet site): www.baumatic.
This appliance is marked according to the European directive 2002/96/EC on Waste electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste.
Baumatic www.baumatic.
