Operation Manual

24
necting the appliance, make sure that the supply voltage
arked on the rating plate corresponds with your mains supply
essible position adjacent to the appliance. The spur
outlet must still be accessible even when your oven is located in
its housing.
nnection, securing the cord in place with the
cable clamp provided and then immediately close the terminal
ange the oven power cord, the earthing
(yellow/green) conductor must always be 10 mm longer than the
o Care must be taken to ensure that the temperature of the mains
aged, then it must be replaced
by an appropriate replacement which can be obtained from the
Baumatic Spares Department.
Electrical connection
Before con
m
voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 13 A double pole switched
fused spur outlet, having 3 mm contact separation and placed in
an easily acc
o To connect the oven power cord, loosen and remove the cover
on the terminal block, in order to gain access to the contacts
inside. Make the co
block cover again.
o If you have to ch
line conductors.
supply cable does not exceed 50°C.
o If the mains supply cable is dam