User manual

17
o Place the clamp (B) over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
hob. Slightly tighten a screw (C) through the clamp (B) so that
st
o
you have cut out.
fully tighten the screws
(C) to secure the hob into position.
Ga c
This appliance must be installed by a competent
n in accordance with the current versions of
the following UK (United Kingdom) or ROI (Republic
t
o his cooker is supplied to run on natural gas only and cannot
r type of gas without modification.
use of
other gases, please contact the Baumatic Technical Department.
o
(Installation and Use) (Amendment) Regulations and the
o
secution under the
regulations quoted above.
o
nd service work, in compliance with
the above regulations.
the clamp is attached to the hob, but so that you can still adju
the position of it.
Carefully turn the hob back over and then gently lower it into the
aperture hole that
o On the underneath of the hob, adjust the clamps into a position
that is suitable for your worktop. Then
s onnection
perso
of Ireland) Regulations and Safety Standards or
their European Norm Replacements.
information Importan
T
be used on any othe
o Conversion for use on LPG and other gases must only be
undertaken by a qualified person. For information on the
The cooker must be installed by a qualified person, in
accordance with the current edition of the Gas Safety
relevant building/I.E.E. Regulations.
Failure to install the appliance correctly could invalidate
Baumatic’s guarantee and lead to pro
In the UK, CORGI registered installers are authorised to
undertake the installation a