User manual

22
as tap maintenance
These maintenance operations MUST ONLY be carried
I registered engineer.
disconne ctricity supplies.
Remove the control knobs, pan supports, burners, hob fixing
bly. Then clean the cone and seating, with
a cloth dampened with solvent.
o
te a few times.
,
with
grease.
o
ss test.
If it b eed
as foll
ews and clamps.
bly.
y removing the fixing screws.
o Reconnect the gas tap, perform a gas soundness test and
G
out by a CORG
IMPORTANT: Before carrying out any maintenance operations,
ct the appliance from the gas and ele
If a gas tap becomes stiff to operate, then you should proceed as
follows:
o
screws and clamps.
o Remove the hob from the worktop and remove any underside
protective covers.
o Disconnect the fixings holding the tap to the fascia panel and
separate the assem
Lightly smear the cone with high temperature grease,
reassemble into position and rota
o Remove the cone again and remove any excess grease
making sure that the gas ducts are not obstructed
Carefully reassemble the components and perform a gas
soundne
ecomes necessary to replace a gas tap, then you should proc
ows:
o Remove the control knobs, pan supports, burners, hob fixing
scr
o Remove the hob from the worktop and remove any underside
protective covers.
o Disconnect the fixings holding the tap to the fascia panel and
separate the assem
o Disconnect the gas pipe from the gas tap, then disassemble
them from the gas rail b
o When fitting a new tap, ensure that a new gasket is used.
then reassemble the hob.