User manual

11
nitial set-up of your oven I
Setting the time of day
After your appliance is connected to your mains supply for the first
time, you must set the time of day before you can use the oven.
When the oven is connected to your mains suo pply for the first time
ing, use the plus (9)
the plus (9) and minus (11) buttons to set the correct
release
the plus and minus buttons and wait a few seconds. The decimal
ill stop flashing and the oven is ready to use.
t from
s cooled, it should then be cleaned with
parts of the oven should be cleaned with warm soapy water,
using either a sponge or soft cloth. No abrasive cleaners should be
used.
(or after a power cut), the digits on the LED display will show
“12:30” and the decimal point (7) will flash.
Whilst the decimal point symbol (7) is flasho
and minus (11) buttons to set the correct hour of day. Press the
program button (10) to confirm the hour.
Then useo
minute of the day. Press the program button (10) to confirm the
minute.
When the correct time of day is shown on the LED display, o
point symbol w
Before first use
To remove any residue from the oven that may have been lefo
the manufacturing process, you should select the fan oven function
and set the thermostat to its maximum temperature setting.
o It is perfectly normal for a smell to be produced during this process.
o You should make sure that any windows in the room are left open
during this process.
o It is advisable for you not to remain in the room whilst the burning
off process is taking place.
o You should leave the oven on maximum setting for 30 – 40 minutes.
After the oven cavity hao
warm soapy water, using either a sponge or soft cloth. No abrasive
cleaners should be used.
Outer o