User manual

24
o IMPORTANT: Please note that the appliance will not spin on this
particular wash cycle.
Rinse + spin program
o Put the laundry into the drum and then close the door.
o Press the power button, the LCD display will show “---“ and all
the program lights will come on.
o Use the wash program selection knob to select the Rinse + Spin
program.
o Use the SPIN button to adjust the spin speed.
o Press the Start/Pause button, the door will lock (confirmed by
the indicator on the LCD display) and after a few seconds you
will hear the machine start fill with water.
o IMPORTANT: Your appliance has an unbalance control system.
If this system detects that the washload is unevenly distributed
inside the drum. Your washing machine will try to redistribute
the load before spinning. If after several attempts it is unable to
redistribute the washload, then the appliance will either spin at a
slower speed or skip the spin cycle and proceed to the drain
section of the wash cycle.
o Uneven load distribution can be caused by too large a wash load
or too small a wash load. It can also occur if a single item is
washed inside the appliance.
End of cycle
o At the end of a wash cycle, the DOOR LOCK light will remain lit
for a couple of minutes.
o IMPORTANT: You should not attempt to open the porthole door
until the DOOR LOCK light has gone out.
o When the DOOR LOCK light has gone out and you hear the door
lock disengage, you can open the porthole door and remove the
laundry.
Pausing a wash program
o If you want to pause a wash program temporarily, you should
press the START/PAUSE button.