User manual

34
o For butane/propane gas, the adjusting screw must be tightly
screwed in.
o Refit the control knob.
o Make sure that the flame does not go out by quickly turning
from maximum flow to minimum flow. If it does then remove
the control knob and make further adjustments to the gas
flow, testing it again once the adjustment has been made.
o IMPORTANT: On completion carry out a gas tightness
test.
Gas adjustment (Conversion to LPG for the oven and grill)
All work must be carried out by a GASSAFE
registered engineer.
IMPORTANT: Always isolate the cooker from the electricity
supply before changing the injectors and/or adjusting the
minimum flow of the burners.
o Remove the burner base from
the bottom of the oven.
o To do so, loosen the two
retaining screws holding it in
place. Then lift the tray from
the back.
o Once it is out, slide the tray
towards the rear and take it off.