User manual

18
aintenance and cleaning M
IMPORTANT: The appliance should be disconnected from the
power supply and allowed to cool before commencing any
either the
new damp cloth with warm
water.
. Therefore the lint filter should be
f the porthole opening. Pull the filter
off the scrap threads and fluff
ated on it.
erate the condenser dryer without
dryer, some water will be
e
res of water can be held in the container drawer.
cleaning process.
Control panel and machine cabinet.
IMPORTANT: Do not use any abrasive
cleaner or household polish on
control panel or operating parts.
o Wipe over the control panel and the
external surface of the machine using a
brand
The lint filter
o The fluff and debris which accumulates on the filter will block the
air circulation which will cause the drying time and energy
consumption to increase
cleaned after each use.
o To remove the filter, open the condenser dryer door and locate
the filter at the base o
upwards to take it out.
o Clean the lint filter by wiping
which have accumul
o Reinstall the filter.
o IMPORTANT: NEVER op
the lint filter in place.
The container drawer
o As this appliance is a condenser
utilised during the drying process.
o This water will be collected in the container drawer next to the
control panel. It should be emptied and cleaned after each use.
o To remove the container drawer pull it gently away from the
machine. Extra care should be taken to avoid any water spillag
as up to 5 lit