User manual

11
oven Initial set-up of your
Setting the time of day
After your appliance is connected to your mains supply for the first
time, you must set the time of day before you can use the oven.
o When the oven is connected to your mains supply for the first
use the plus (9)
plus (9) and minus (11) buttons to set the correct
e the plus and minus buttons and wait a few seconds. The
hing and the oven is ready to
manufacturing process, you should select the fan oven
n be cleaned with
time (or after a power cut), the digits on the LED display will
show “12:30” and the decimal point (7) will flash.
o Whilst the decimal point symbol (7) is flashing,
and minus (11) buttons to set the correct hour of day. Press
the program button (10) to confirm the hour.
Then use theo
minute of the day. Press the program button (10) to confirm
the minute.
o When the correct time of day is shown on the LED display,
releas
decimal point symbol will stop flas
use.
Before first use
o To remove any residue from the oven that may have been left
from the
function and set the thermostat to its maximum temperature
setting.
o It is perfectly normal for a smell to be produced during this
process.
o You should make sure that any windows in the room are left
open during this process.
o It is advisable for you not to remain in the room whilst the
burning off process is taking place.
o You should leave the oven on maximum setting for 30 – 40
minutes.
o After the oven cavity has cooled, it should the
warm soapy water, using either a sponge or soft cloth. No
abrasive cleaners should be used.