User manual

24
ock, in order to gain access to the contacts
inside. Make the connection, securing the cord in place with the
o If you have to change the oven power cord, the earthing
o If the mains supply cable is damaged, then it must be replaced
by an appropriate replacement which can be obtained from the
nstalling
o The oven must be fitted into an oven housing with the ventilation
o Ensure that the rear panel of the furniture housing unit has been
removed.
o To connect the oven power cord, loosen and remove the cover
on the terminal bl
cable clamp provided and then immediately close the terminal
block cover again.
(yellow/green) conductor must always be 10 mm longer than the
line conductors.
o Care must be taken to ensure that the temperature of the mains
supply cable does not exceed 50°C.
Spares Department.
I the oven into a kitchen cabinet
Positioning the appliance
o Ensure that the aperture that you will be fitting the oven into is
of the size given in the above diagram.
cut-outs shown in the “Ventilation requirements” on the next
page.