Instruction manual

Electrical connections

Before connecting the oven to the mains power supply,

make sure that: - The supply voltage corresponds

to the specifications on the data plate on the front of the

drawer. - The mains supply has an efficient earth

(ground) connection complying with all applicable laws

and regulations. Correct earthing (grounding) is a legal

requirement. The power cable should never reach a

temperature 50° C above ambient temperature at any

point along its length. If a ﬁxed appliance is not provided

with a power cable and plug, or some other device

permitting it to be disconnected from the mains electricity

supply, with a gap between the contacts big enough to

guarantee class III overvoltage protection, then such a

device must be ﬁtted to the power supply in compliance

with

the regulations governing electrical installations.

The socket or switch must be easily reachable with the

oven/drawer fully installed.

CABLE TYPES AND MINIMAL DIAMETERS

SASO

H05RR-F 3x0,75 mm² H05RR-F 3x1,5 mm²

H05VV-F 3x0,75 mm² H05VV-F 3x1,5 mm²

H05RN-F 3x0,75 mm² H05RN-F 3x1,5 mm²

H05V2V2-F 3x0,75 mm² H05V2V2-F 3x1,5 mm²

WARNING! Before connecting the warming drawer

to the electrical circuit, verify that the voltage and the

frequency correspond to those indicated on the label

located inside the heating block, which should be kept

along with this manual.

The electrical attachment must be made using bipolar

switch capable of powering the appliance and that has

a gap of 3 mm (minimum) to guarantee disconnection

in case of emergency or when cleaning the warming

drawer.

Connect the appliance to the ground circuit to conform to

safety regulations regarding electrical systems.

ATTENTION! THE WARMING DRAWER MUST BE

CONNECTED TO THE GROUND CIRCUIT.

In the event of the failure of the cable supplied with the

warming drawer, replace it with an original replacement

part provided by the Service Department.

The manufacturer and retailers will not be liable for

property damage and personal injury caused by a failure

to follow the instructions provided in this manual.