Operating instructions

BAUMATIC BDW45.1 dishwasher user manual
12
12
STARTING A WASH CYCLE
1) MAKE SURE THAT YOUR DISHWASHER’S
PLUG HAS BEEN PUSHED ALL THE WAY INTO
THE WALL SOCKET.
2) MAKE SURE THAT THE WATER SUPPLY IS
TURNED ON TO FULL PRESSURE.
3) LOAD YOUR DISHWASHER (SEE THE
SECTION ENTITLED ‘LOADING YOUR
DISHWASHER’, PAGES 8-11).
4) POUR IN DETERGENT (SEE THE SECTION
ENTITLED ‘SALT, DETERGENT & RINSE AID’),
PAGES 5-7.
5) OPEN THE DOOR, PRESS THE
‘ON/OFF’ BUTTON AND THE
‘ON/OFF’ LIGHT WILL COME ON.
6) PRESS THE ‘P’ KEY (PROGRAM KEY)
TO SELECT THE ‘WASH CYCLE’. SEE
TABLE ON NEXT PAGE FOR WASH
CYCLE TYPES.
7) CLOSE THE DOOR. THE WASHING
WILL START AFTER
APPROXIMATELY TEN SECONDS.
* REMEMBER*: YOU CAN PROGRAM YOUR DISHWASHER UP TO 24 HOURS IN ADVANCE BY PRESSING
THE DELAY BUTTON MULTIPLE TIMES UNTIL THE DESIRED DELAY HAS BEEN SET.
.
Approximate Timing of Wash Cycles
Intensive
(strong) 127
mins.
Normal
117
mins.
Economy
102
mins.
Rinse
50
mins.
Glass
70
mins.
Rapid
45
mins.
Soap
7
mins.
Note: When you turn your dishwasher on, the number ‘OO’ should show on the display. If you see an
y
other digits, such as ‘17’ or ‘01’, ‘02’, ‘03’, etc., please refer to the trouble-shooting section on page 19.
The Delay Timer key will set the start of the washing cycle by one hour into the future for every press.
4
5
6
7
88
The Delay Timer key is in the figure as the button numbered ‘5’.