Operating instructions

BAUMATIC BDW45.1 dishwasher user manual
19
BEFORE YOU CALL FOR SERVICE …
CHECKING AGAINST THE CHARTS BELOW MAY FIX YOUR PROBLEM.
19
PROBLEM POSSIBLE CAUSES WHAT TO DO
• Fuse blown, or the
circuit breaker acted
• Replace fuse or reset circuit breaker.
• Remove any other appliances
feeding from the same socket as the
dishwasher.
• Power supply is not
turned on
• Make sure the dishwasher is turned
on and the door is closed securely.
• Water pressure is low
• Check that the water supply is
connected properly and the water is
turned on.
Dishwasher
doesn’t run!
• … And (situation A)
the number 17 is
showing on the display.
This means that your
dishwasher has
entered Test Mode – a
factory sequence which
you need not concern
yourself with. This
happens because the
Delay Timer key was
pressed before the
‘ON/OFF’ key was
pressed.
• …Or (situation B) the
display shows one of
the following: 0A, 09,
08, 07, 06, 05, 04,
03, 02, 01, 00.
• For situation A, Press and hold
down the Delay Timer key at the
same time as you’re pressing the
‘ON/OFF’ button to switch the
dishwasher off. Wait a few
seconds then press only the
‘ON/OFF’ button again. You are
now ready to program your
dishwasher for a washing cycle as
per usual.
• For situation B, Press ‘ON / OFF’
button to turn the dishwasher off.
Then, press and hold down the
Program Key (‘P’) at the same
time as you’re pressing the ‘ON /
OFF’ button to switch the dishwasher
on again. You are now ready to
program a cycle as per usual.
Drain Pump
doesn’t stop!
• Overflow
• The system is designed to detect an
overflow. When it does, it shuts off
the circulation pump and turns on
the drain pump. Call a Baumatic
Ltd approved technician.