Operating instructions

BAUMATIC BDW45.1 dishwasher user manual
31
f) NOW YOU ARE READY TO CONNECT THE
POWER CORD.
WARNING!
ELECTRICITY CAN BE DANGEROUS. PLEASE READ THE FOLLOWING
CAREFULLY
:
ELECTRICAL CONNECTION
Electrical Requirements
The dishwasher is designed for operation on an adequately wired individual 220-240V AC, 50Hz
system. The required fuse rating is 13amp. Fused electrical supply is required – copper wire
only. Time delay fuse or circuit breaker is recommended. Make sure that this appliance
runs off its own separate circuit. Outlet should be placed in adjacent cabinet.
WARNING – ENSURE PROPER GROUND EXISTS BEFORE
USE.
After making sure that the voltage and the frequency values for the current in your home
correspond to those on the rating plate and that the electrical system is sized for the maximum
voltage on the rating plate, insert the plug into an electrical socket which is earthed properly. If
the electrical socket to which the appliance must be connected is not right for the plug, replace
the socket, rather than using adaptors of the like as they could cause overheating and fire.
31
g) NOW, PUT THE DISHWASHER ON THE SLIDE
RAILS (These are supplied so your appliance can be pushed into place
easily and to protect your floor surface from pressure points). See figure at
bottom of page.