User manual

Cleaning the filters

For best performance and results, the entire filter assembly should be

thoroughly cleaned regularly (ideally after each wash cycle).

1. Turn the coarse filter anti-

clockwise and then lift it

upwards. Rinse out this

section under a tap to

remove any food debris

that remains in it.

o The fine filter will lift out with the coarse filter, this should be

rinsed under the tap to remove and food debris that is trapped in

it.

2. Pull the main filter

upwards and rinse it

under the tap to remove

any food debris that is

trapped in it.

3. Replace all three of the filters into their original positions. You

must turn the coarse filter clockwise to lock it back into position.

IMPORTANT: When the

filters are removed from

the dishwasher, you MUST

NOT touch the sump water

flow guide (A) or the

turbidimetre (B).

Otherwise it may result in

a water leak.

IMPORTANT: If a glass gets smashed inside of the appliance,

you must check there is no glass in the filter before the

machine is used again as this can cause a drainage failure.

IMPORTANT: THE DISHWASHER SHOULD NEVER BE

SET ON A WASH CYCLE WITHOUT THE FILTERS BEING

INSIDE OF THE APPLIANCE.