User manual

27
r slightly to prevent an unpleasant odour
from developing.
o Clean all of the filters and dry the inside of the machine
econnecting the appliance after a period of disuse
If the appliance has not been used for a prolonged period of time, then
that you do
llowing:-
o Check that no sludge or rust has built up in the pipes. If this has
o Reconnect the inlet hose and outlet hose, making sure that the
o Reconnect the appliance to your mains supply.
nstallation
o Disconnect the electrical and water connections.
o Leave the door aja
thoroughly.
R
before using the appliance again, we would recommend
e foth
happened, let water run through the tap for a few minutes.
water tap is open.
I
Installation of this appliance must be carried out by a
suitably qualified person, in accordance with the
orm
IEE Wiring Regulations.
At Work Regulations.
n
marked o
voltage.
ED BY A SUITABLY QUALIFIED PERSON.
ANCTION THE INSTALLATION
N MANUAL. YOU SHOULD
current version of the following.
o UK Regulations and Safety Standards or their European N
Replacements.
o Building Regulations (issued by the Department of the
Environment).
o Building Standards (issued by the Scottish Development
Department).
o
o Electricity
necting the appliance, make sure that the supply voltage
n the rating plate corresponds with your mains supply
Before co
WARNING: THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: THIS INSTALLATION MUST BE
COMPLET
BAUMATIC ONLY S
GIVEN IN THIS INSTRUCTIO