User manual

33
o Fix the screws on both sides to ensure the dishwasher cannot be
o Replace the cap.
necting to the mains water supply
IMPORTANT: Do not connect the appliance to your mains
o Connect the inlet hose to the inlet valve on the rear of the
o Connect the water inlet hose to a
o Fully tighten the inlet hose to the water
o The water supply to the appliance can
exceed 60°C at a
o If the temperature exceeds this limit, the wash cycle length will
o The connection to the hot water line can be made by following
moved from the cabinet.
Con
water supply using an old or an existing water inlet hose.
The inlet hose supplied with the dishwasher is the ONLY one
that should be used.
product. Please refer to the photographs above to see the
correct position that the inlet hose should be in when connected.
threaded water tap that has a 3/4”
thread.
tap and the dishwasher.
also be connected to the house’s hot
water line, or centralised heating system,
as long as the temperature does not
ny time.
be reduced and the efficiency of the appliance will be
dramatically lower.
the same procedure as above for the cold water line.