Owner's Manual

Intense and economy wash indicator neons flash
o The machine has sensed water in the base.
9 Check that the outlet hose is not kinked or crushed.
9 Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
9 The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds, before attempting to set a wash program, using the
program selection button.
IMPORTANT: If any other fault code appears you should
not attempt to clear it yourself and contact the Baumatic
Service Department.
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
SUPPLY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOULD CONTACT
BAUMATIC SERVICE ON TELEPHONE NUMBER (0118)
933 6911.
26
ALL.
IF AN ENGINEER ATTENDS DURING THE GUARANTEE
PERIOD AND FINDS THAT A FAULT HAS BEEN
CAUSED BY AN ITEM ON THE ERROR CODE LIST,
WHICH COULD HAVE BEEN CLEARED BY THE
CUSTOMER. THEN YOU MAY BE LIABLE FOR THE
COST OF THE SERVICE C