Operation Manual

23
Changing the wash program
o Turn off the power using the ON/OFF button.
o Wait for a minute and then open the door of the appliance.
o Turn the appliance on by using the ON/OFF button and wait for 5
seconds before pressing the program selection button.
o Press and hold down the program selection button of the wash
program that was in progress for 3 seconds to cancel the wash
program. Then press another program selection button to choose
the correct wash program.
o Select any program options that you want to use (e.g. delay
start or half load).
o Close the door firmly, so that you hear the door lock click shut.
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
At the end of a wash program
o At the end of a wash program a buzzer will sound.
o Open the door of the appliance.
o Use the ON/OFF button to switch the dishwasher off.
o Wait for a few minutes before unloading the dishwasher.
o You should avoid handling dishes and utensils whilst they are still
hot, as they are more susceptible to breakage.
The 3 in 1 wash program
Make sure that the water softener has been filled with salt
and that the water softener has been set to its lowest
setting.
Make sure that the rinse aid dispenser has been set to an
appropriate level.
THIS WASH PROGRAM MUST BE SELECTED IF YOU ARE USING 3
IN 1 DETERGENT. IF YOU USE ANY OTHER WASH PROGRAM
WITH 3 IN 1 TABLETS, THEN YOU MAY GET POOR WASH
RESULTS.