Operating instructions

d) Connecting to the mains water supply
IMPORTANT: Do not connect the appliance to your mains water supply
using an old or an existing water inlet hose. The inlet hose supplied with
the dishwasher is the ONLY one that should be used.
DO NOT CONNECT THE WATER INLET HOSE TO A HOT WATER TAP.
o The inlet hose will be located inside the cabinet of the dishwasher.
o Connect the water inlet hose to a threaded water tap that has a 3/4” thread.
o Fully tighten the inlet hose to the water tap.
IMPORTANT: If the inlet hose is fitted with an aqua stop. This
MUST be fitted in the upright position, as shown in the above
diagram.
e) Connecting the drain hose
9 Secure the drain hose, so that it cannot move whilst the dishwasher is in use.
9 Place the end of the drain hose on your drain pipe. Push it a short way down
into your drain pipe.
9 IMPORTANT: Do not insert the drain hose too deeply into the water pipe, as
this may cause siphoning.
30
9 NEVER EXTEND THE DRAINAGE HOSE FROM ITS ORIGINAL LENGTH.