User manual

40
Securing the dishwasher
o The dishwasher must be secured to the o
done in one of two ways:-
o Standard worktop- Secure the dishwasher to the
underside of the worktop by using
o You should screw through the holes in the brackets at the
top of the dishwasher cabinet.
o These screws should be fully tightened.
o Marble/granite worktop- The material of the worktop
will mean that it is impossible to put a screw through the
underneath of the worktop.
o On either side dishwasher cabinet,
there is a rubber stopper. You should remove the rubber
stoppers, to reve a
dishwasher.
o Secure the dishw h
screwing a wood screw through the pre-drilled holes into
the cupboards These screws should be fully tightened.
o The rubber stoppers should then be refitted into their
original position.
efore first use
ou should check the following before using the appliance for the first
me:-
o That the dishwasher is level and fixed in position.
o That the water tap is fully open.
o That there are no leaks at either end of the drain or inlet hoses.
t hose are fully tightened.
o t hoses are not kinked.
d
o Th t
w rktop, this can be
two wood screws.
of the front edge of the
al pre-drilled hole on either side of the
as er to the cupboard either side of it, by
.
B
Y
ti
o That the inlet and outle
That the inlet and outle
o That the power is switched on.
o That the water softener has been filled with 1 litre of water an
salt.
at he rinse aid dispenser has been filled.