User manual

12
ater softener, whilst you are filling it with salt. This does not
mean that the water softener is filled with the correct amount of
t. Thereafter, when
the salt indicator neon lights on the control panel, you should follow
T: You do not need to pour 1 litre of water into
the container when you subsequently fill the water softener
wash cycle. The water softener should be set to a
vel for the hardness of
the t
o It is perfectly normal for a small amount of water to come out of
the w
salt.
o Refit and fully tighten the water softener cap.
o The salt required warning light will go out approximately 2-6 hours
after you have filled the water softener with sal
the filling with dishwasher salt procedure again.
o IMPORTAN
with salt.
Setting the water softener level
It is possible to regulate the amount of salt that the water softener will
release during a
le that is appropriate
able below).
your water (please refer to
WATER HARDNESS
Clarke
degrees
°dH German
Degrees
°TH ch
degrees
Selector
position salt used
per cycle cycles per 1
kg of salt
Fren
Grams of Approximate
number of
0-10 0-8 0-14 N/A 0 N/A
11-28 9-22 15-39 Minus symbol 20 50
29-56 23-45 40-80 Middle 40 25
57-75 46-60 81-107 Plus symbol 60 16
To alter the amount of salt that is released by the water softener, you
e lower basket and unscrew the cap from the water
Locate the ring with an arrow on it that is located
You should turn the arrow to the setting that is
The “middle” selector position is halfway between
ard water area, then you should still fill the water
e water softener arrow should be turned to the
minus setting.
should:-
o Remove th
softener.
o
on the water softener. (See figure opposite).
o
appropriate for your water hardness.
o
the minus and plus symbols.
o IMPORTANT: If you are using 3 in 1 dishwasher tablets and live in
a medium or h
softener with salt. Th