User manual

28
rror code failure system E
f your appliance senses that it is not operating coI rrectly, then an error
ed below should be followed.
MAINTAINEANCE ON THE
OUR MAINS
water pressure of your mains water supply.
lean the mesh filter that sits in the inlet hose.
ushed.
ed to is turned
at there are no blockages in the drain hose or the drainage
fault code to appear, plug the machine back into your
on and wait for 5
c
a
o .
IMPORTANT: If any other fault code appears in the display
window, you should not attempt to clear it yourself and
contact the Customer Care Department.
code may appear in the display window.
The following error codes can possibly be remedied by the customer
nd the steps outlina
BEFORE COMPLETING ANY
APPLIANCE, IT SHOULD BE DISCONNECTED FROM Y
POWER SUPPLY.
E1
o Longer than expected fill time.
Check the
 C
 Ensure that the inlet hose is not kinked or cr
 Make sure the water tap that the machine is connect
on fully.
E4
o The machine has sensed water in the base.
 Check that the outlet hose is not kinked or crushed.
Check th
system that the appliance is connected to.
 The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
orrect. c
o Once you have taken action to rectify the problem that has
caused the
mains power supply.
o Turn the machine on using the ON/OFF butt
se
o W
pr
onds.
it for a further 5 seconds before attempting to set a wash
ram, using the program selection buttong