User manual

34
to springs. These are set at
the proper tension, so that
to adjust the tension
ey,
tighten or slacken
rs’ spring
tension is correct
when:-
a) The door remains horizontal when in the fully opened
b) You are able to shut the door easily, by raising the door using
WARNING: If you do not adjust the tension of the door spring,
nce.
ter
supply using an old or an existing water inlet hose. The inlet hose
The inlet hose will be located inside the main
threaded
water tap (A) that has a 3/4” thread and to
n the inlet hose to the water tap
and the di
shwasher.
Adjusting the tension o
f the door spring
o The door of the dishwasher is attached
the factory to ensure that they are at
the door can open and close smoothly.
o After the furniture
door has been
fitted, you will need
of the door spring.
o Using an Allen k
rotate the adjusting
screw to either
the steel cable.
o The doo
position.
your fingers.
o
then it could cause damage to the applia
Connecting to the mains water supply
IMPORTANT: Do not connect the appliance to your mains wa
supplied with the dishwasher is the ONLY one that should be used.
DO NOT CONNEC T THE WATER INLET HOSE TO A HOT WATER TAP.
o
compartment of the dishwasher.
o Connect the water inlet hose (C) to a
the inlet hose connector on the appliance.
o Fully tighte