Operation Manual

WWW.MANUALS.WS
WWW.MANUALS.WS
9. Sit the coffee machine in the housing unit. You must make sure
that the coffee machine is flush with the housing unit, otherwise
it will not line up properly with the support pieces.
IMPORTANT: You must complete the water connection at
this stage, if you are going to connect the appliance to
your mains water supply.
Do not proceed with the rest of the installation steps listed
below, until you have completed the “Connecting the coffee
machine to the mains water supply” section on page 30.
You should also feed the electrical cable through the hole that you
have made for it in the housing unit. You should NOT connect the
cable to the spur outlet at this stage.
29
10. Locate the screw position in the top right
hand corner of the rear panel.
11. Using the Allen key provided, tighten a
screw through the top right hand hole in
the rear panel, into the support piece
that is behind it.
12. Lift the backplate back into position and refit the screws that you
removed in step 7.
13. Use the Allen key to tighten a screw through the bottom right
hand hole in the rear panel, into the support piece that is behind
it.
14. Open the reservoir door to locate the position of the left hand
screw holes. Use the Allen key to tighten a screw through both of
these holes, into the support piece that is behind them.
IMPORTANT: You must make sure that the four screws that go into
the support pieces are fully tightened.
15. Follow the electrical connection information on page 26 and then
check that the appliance is functioning correctly.