BEC455TS Fully automatic built in coffee machine 1
User Manual for your Baumatic BEC455TS Fully automatic built-in coffee machine NOTE: This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference; for you or any person not familiar with the operation of the appliance.
Contents Environmental note IMPORTANT SAFETY INFORMATION 4 5–6 Specifications Product and aperture dimensions Product specifications Standard accessories Technical specifications Description of the coffee machine Control panel 7 – 11 7 8 8 8 9 10 - 11 Before first use Cleaning Filling the water tank Filling with coffee beans Using your coffee machine Turning the coffee machine on Coffee grind regulation Making coffee Dispensing hot water Dispensing steam 12 12 12 14 14 14 15 16 17 18 Settings Programm
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment.
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line. General Information o This appliance is designed for domestic household use only. It can ONLY be built into a standard kitchen cabinet or housing unit and should NOT be used as a freestanding appliance.
Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch the appliance at any time. o If it is necessary for younger family members to be in the kitchen, please ensure that they are kept under close supervision at all times. General Safety o Do not leave the coffee machine unattended when in use. o Do not allow electrical fittings or cables to come into contact with areas on the appliance that get hot.
Specifications Product Dimensions Aperture Dimensions Height: Width: Depth: Height: Width: Depth: 453 mm 598 mm 533 mm 458 mm 560 mm 560 mm Product specifications o o o o o o o o o o o Touch control operation Mark resistant coating Choice of 1 or 2 cups Steam spout for cappuccino, hot chocolate, tea and instant coffee Coffee quantity regulation Drawer for coffee beans (capacity 400g) Regulation knob for grinding coffee beans Empty water tank indicator Empty coffee grounds container indicator Pull-ou
Standard accessories o Telescopic runners for appliance extraction Technical specifications Coffee / steam pump pressure: Coffee boiler output Steam boiler output Water tank capacity: MAX connected load: Power supply Supply connection fused o Mains supply lead o o o o o o o 12 bar 500 W 1200 W 2.5 litres 2.00 kW 230 Vac 50 – 60 Hz 13A (double pole switched outlet with 3 mm contact gap) 3 x 1.
Description of the coffee machine 1) 2) 3) 4) 5) 6) 7) 8) 9) Water tank Decalcifying filter Dispenser Water / steam dispensing nozzle Drip tray Coffee container Grind regulation knob Control panel Door / tray for emptying the coffee grounds 9
Control panel ON / OFF button START / STOP button ESPRESSO COFFEE button REGULAR COFFEE button WATER button Fill water tank indicator Empty coffee grounds indicator Malfunction warning indicator SELF-CLEANING cycle button LIGHT button TWO ESPRESSO COFFEES button 10
TWO REGULAR COFFEES button STEAM button Replace filter indicator Coffee probe malfunction indicator COFFEE QUANTITY REGULATION button Light coffee indicator Medium coffee indicator Strong coffee indicator 11
Before first use 1) Cleaning o It is strongly recommended to clean the appliance prior to its first use. Particular attention should be paid to the water tank. o For further information on cleaning the appliance, please refer to the cleaning instructions on pages 24 - 26. o Install the appliance as per the installation instructions contained within this booklet. 2) Filling the water tank o Before filling the water tank, ensure that the decalcifying filter is soaked in cold water for at least 20 minutes.
o Remove the water tank lid and insert the decalcifying filter as shown in the diagram on the left. Press the filter into place until you hear a click. o The water in the tank should be changed regularly, especially if the machine has not been used in a long time. o Replacement filters can be purchased from many appliance stores or supermarkets. o Remove the water tank by pulling it upwards out of the coffee machine as shown in the diagram on the left. o Fill the water tank with drinking water.
3) Filling with coffee beans o IMPORTANT: Before pouring coffee beans into the container, you should check that there are no foreign bodies inside. o Open the coffee container lid and pour approximately 200g of coffee beans into the container as shown in the diagram on the left. o Carefully push the machine back into the furniture housing until you hear a click. This indicates that the machine is locked into place.
o Press the ON / OFF button. The LED lights will flash before turning on which indicates that the machine is ready to use. o IMPORTANT: If the coffee machine is not used for 45 minutes, it will return to stand-by mode. Coffee grind regulation IMPORTANT: The fineness of the coffee grind is initially set at the default factory setting. The fineness can be adjusted to suit personal taste. o A grind that is too coarse produces coffee that flows too quickly without creaminess and body.
Making coffee o The dispensing time for an excellent espresso coffee is about 15 – 25 seconds. Factors that can influence the dispensing time are the fineness of the coffee grind and the quantity of ground coffee. You can adjust either of these settings by following the relevant instructions in this manual. o Place one or two cups under the dispenser and adjust the height of the dispenser nozzle. Turning the dial raises or lowers the nozzle accordingly.
Dispensing hot water IMPORTANT: Please note that the main boiler and the steam boiler CANNOT be operated at the same time. o IMPORTANT: You should not dispense immediately after dispensing steam. hot water o Before dispensing hot water, place the water / steam nozzle in a suitable position and place a container beneath it. o Press the WATER button. o Press and hold the START / STOP button within 10 seconds of selecting the hot water function.
Dispensing steam IMPORTANT: Please note that the main boiler and the steam boiler CANNOT be operated at the same time. o Press the STEAM button. The indicator light will flash for about 15 seconds. When the indicator light stops flashing and remains on this shows that the machine is ready to produce steam. o Place the water / steam nozzle in a suitable position and place the container of liquid to be heated below the nozzle. o You should ensure that the nozzle is fully immersed in the liquid.
Settings Programming the quantity of ground coffee o You are able to choose from 3 strengths of coffee which are light, medium and strong. o To change the strength of coffee, press the COFFEE QUANTITY REGULATION button repeatedly. The LED for the selected coffee strength will light. o One bean indicates a light strength, two beans indicate a medium strength and 3 beans indicate a strong coffee.
Restoring the factory settings o The coffee machine is programmed at the factory for Italianstyle espresso coffee and German-style regular coffee. o If changes have been made to the settings and you wish to revert to the default factory programming, you must press and hold the COFFEE QUANTITY REGULATION button for about 6 seconds when the machine is in standby mode. o All of the LEDs, except the ON / OFF button will flash for 5 seconds and after this the factory settings will be restored.
Replace the filter warning o When the coffee machine has dispensed 80 litres of water, the replace filter indicator will start to flash. o When the machine has dispensed 100 litres of water, the replace filter indicator will turn on. o This prompts you to replace the decalcifying filter with a new one by following the instructions on pages 12 – 13. o It is recommended that the filter is replaced within 3 months from when the replace filter indicator turns on.
Recipes Cappuccino An espresso topped with an equal amount of steamed milk and froth. o IMPORTANT: When making a cappuccino, the steam boiler should be heated before the main boiler in order to reduce the time taken to heat up the main boiler. o After making a cup of espresso, you should follow the dispensing steam section on pages 18 – 19. o Using a suitable jug fill approximately 150 - 200 ml of milk required for frothing. o Heat the jug of milk using the steam function.
Cold espresso chilled in a shaker o Make an espresso by following the relevant instructions in this manual. Add sugar and then immediately pour into a shaker with large cubes of ice and shake for several seconds. o Serve in a tumbler or flute glass. Irish coffee o Make a regular coffee by following the relevant instructions in this manual. Pour in a single measure of whiskey and cane sugar.
Cleaning and maintenance Cleaning operations must only be carried out when the coffee maker is cold. The appliance should be disconnected from your mains supply before commencing any cleaning process. Stainless steel sections o The stainless steel sections should be cleaned using warm soapy water. o No abrasive detergents or cleaners should be used. o No abrasive sponges or steel wool should be used on any area of the appliance. o Dry the appliance afterwards thoroughly with a soft cloth.
Drip tray o Remove the drip tray from the coffee machine as shown in the diagram below. o Make sure that you empty the drip tray regularly to avoid liquid spills that could ruin the furniture below. o The basin and metal grill can be washed in warm soapy water or placed in a dishwasher. Water tank o If you have not used the coffee machine in a long time, it is recommended that you change the water in the tank. o The water tank should be cleaned regularly to avoid lime-scale build-up.
o Remove the coffee grounds tray, empty the coffee grounds and wash the tray with warm soapy water or place it in the dishwasher. o Replace the coffee grounds tray back into its correct position. Self-cleaning cycle o You are able to set the coffee machine to carry out a self-cleaning cycle when the machine is turned on and not in stand-by mode. o Press the SELF-CLEANING CYCLE button followed by the START / STOP button and the coffee machine will begin the washing process.
INSTALLATION Installation of this appliance must be carried out by a suitably qualified person, in accordance with the current version of the following. o UK Regulations and Safety Standards or their European Norm Replacements. o Building Regulations (issued by the Department of the Environment). o Building Standards (issued by the Scottish Development Department). o IEE Wiring Regulations. o Electricity At Work Regulations.
Electrical connection Before connecting the appliance, make sure that the supply voltage marked on the rating plate corresponds with your mains supply voltage. WARNING: THIS APPLIANCE MUST BE EARTHED. o This appliance should be wired into a 13 A double pole switched fused spur outlet, having 3 mm contact separation and placed in an easily accessible position adjacent to the appliance. The spur outlet must still be accessible even when your coffee machine is located in its housing.
Installing the coffee machine into a kitchen cabinet Positioning o Ensure that the aperture that you will be fitting the coffee machine into is of the size given in the diagram above. o Ensure that the rear panel of the furniture housing unit has been removed and that the ventilation cut out shown is adhered to. o It is recommended to install the appliance at a certain distance from refrigerators or freezers as the heat it emits could affect their operation.
Installation of the coffee machine o Position the fixed machine support (1) by resting it on the base surface of the furniture cut-out. o The width of the furniture housing cut-out will be affected by the thickness of the sides of the furniture. The side plates can be used to compensate for any empty spaces. o Four plates are supplied to compensate for the different width measures. There are two which are 2mm thick (6) and two which are 1 mm thick (5).
o Then mount the 2 lateral guides (4) onto either side of the housing using the remaining self-threading screws. o Insert the coffee machine into the housing unit by matching up the guides on the sides of the machine with the supports already mounted in the housing unit. o Slide the coffee machine all the way in until the safety stops click, locking the appliance into position.
TROUBLESHOOTING My coffee machine will not work at all. o Check your mains supply and the electrical connection. My coffee machine will not dispense water. o Check that the water tank is filled with water. Is it ‘OK’ to leave my espresso machine switched ON? o The appliance should not be left unattended when the drinks making process is in progress. o The appliance will go in a stand by mode when not in use after approximately 45 minutes. To restart press the ON / OFF button.
Coffee glossary Caffe- Italian word for a standard espresso Caffe Americano- a thin espresso with water added Caffe latte- a double espresso mixed in a large cup with hot milk. It should be topped with little or no foam. Caffe mocha- made from equal parts milk and cocoa. Caffeine- espresso’s caffeine content is only a third or half of that found in coffee. The stronger the roast, the less caffeine the espresso will contain. Cappuccino- is espresso frothed with milk.
IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your mains supply and then contact the Customer Care Department on telephone number (0118) 933 6911. DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. The manufacturer has the right to change any specifications on the product without giving prior notice.
Baumatic consumables o BC001 Degreaser for Dishwashers (200g) o BC002 Descaler for Washing Machines and Dishwashers (200g) o BC003 Ceramic Hob Cleaner (250ml) o BC004 Oven Cleaner (250ml) o BC005 Stainless Steel Cleaner and Protector (250ml) o BC007 E-Cloth – General Purpose Cloth o BC008 Microwave Cover To order a Baumatic consumable product please call 0123 5437 244 and quote the product code. You can also order online from eshop.baumatic.co.
United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Customer Care Telephone (0118) 933 6911 Customer Care Fax (0118) 986 9124 Spares Telephone (01235) 437244 Advice Line Telephone (0118) 933 6933 E-mail: sales@baumatic.co.uk customercare@baumatic.co.uk spares@baumatic.co.uk technical@baumatic.co.uk Website: www.baumatic.co.uk Facebook: www.facebook.com/baumatic.
