User manual

22
o Fix the upper chimney section to the hanging plate, using the 4 x
self tapping screws.
o Slide the lower chimney section onto the angle bars and raise it
until it sits just below the upper chimney section.
o Use the hanging hook to temporarily keep the lower chimney
section in this position, to make sure that it does not drop down
whilst fixing the main body of the hood to the angle bars.
5) If you are going to be using the hood in extraction mode, you
should fit the spigot for the duct hose onto the main body of the
cooker hood, using the 4 x M4 bolts.
6) Lift the main body of the cooker hood onto the angle bar and
then fix it into position using the 16 x M4 bolts.
o IMPORTANT: This stage of the installation process MUST
be completed by two people.
o IMPORTANT: The 16 x M4 bolts MUST be securely
tightened.
8) If you are going to be using the hood in extraction mode, you
should fix the ducting hose to the spigot.