Operating instructions

BAUMATIC BFD47SS dishwasher user manual
14
FORGET TO ADD A DISH?
A FORGOTTEN DISH CAN BE ADDED AT ANY TIME BEFORE THE DETERGENT
DISPENSER
OPENS.
• OPEN THE DOOR A LITTLE TO STOP THE WASHING.
• WAIT ABOUT TEN SECONDS. AFTER THE SPRAY ARMS STOP WORKING,
YOU
CAN OPEN THE DOOR COMPLETELY.
• ADD FORGOTTEN DISHES.
• CLOSE THE DOOR, THE DISHWASHER WILL WORK AFTER TEN SECONDS.
NEED TO INTERRUPT A CYCLE?
If an emergency arises , you can stop the machine at any time. Remember to wait
approx. 10 seconds before you open the door fully, as the spray arms continue to turn
after
the power has been cut and could spray hot water up at you. DO NOT PRESS
THE ON/OFF BUTTON AS THIS WILL RESET THE WHOLE WASH CYCLE! YOU
JUST NEED TO PULL THE DOOR OPEN – DO NOT TOUCH ANY BUTTONS!
NOTE :
If you need to change a cycle , you can as long as the dishwasher has only been
running
for a short time. Just press the ON/OFF button so the ON light goes out, turn
the knob to the setting you want then turn the dishwasher back on with the ON/OFF
button.
However, if it’s been a long time since the old cycle began, the detergent may have
already
been released and the wash water drained out. You’ll need to start a new
cycle altogether so press the ‘ ON/OFF’ button to switch the dishwasher off, wait until
the inside cools before you refill the detergent dispenser, close the door and then turn
the
knob to the cycle setting you want before you turn your dishwasher back on.
TAKE CARE WHEN OPENING THE DOOR DURING
WASHING.
THE HOT WATER MAY SCALD YOU!
AT THE END OF THE WASH CYCLE
14
• When the washing cycle timer counts back to zero, you will hear a beeping
sound
for a few seconds, meaning that the washing cycle has now finished.
• The display will read ‘END’ for about three minutes.
• Turn the dishwasher off using the ON/OFF button and open the door of the
dishwasher.
• Wait a few minutes before unloading the dishwasher so the dishes can cool
down.
This will make them less breakable and allow them to dry better.