User manual

Cancelling a wash program
9 To stop a wash program once a wash cycle is in progress, press
the START/STOP button and keep it depressed until the READY
END light comes on.
o The LOCK DOOR light will remain on. A key symbol will
appear in the LCD display.
o After two minutes the LOCK DOOR light will go out and the key
symbol will no longer appear on the LCD display. At this point it
is possible for you to open the door and take out the washload.
Before opening the porthole door, you MUST
select the DRAIN program. Otherwise there
may still be water in the drum when you
open the door.
Changing a wash program
o If you have accidentally selected the wrong wash program, then
it is possible to change it to the correct one.
9 Press the START/STOP button to pause the wash cycle.
9 Turn the program selection knob to the wash program that you
wanted to select originally.
9 Select any relevant program options using the four buttons
underneath the LED display.
9 Press the START/STOP button.
Please note that this process must not be
used to cancel a wash program. You should
follow the “Cancelling a wash program”
section to do this.
o If the program selection knob is turned mid wash cycle without
the “Changing a wash program” process being followed. Then
the originally selected wash program will continue and complete
as normal.
o The LCD display will show the letter P and the number of the
wash program that you originally selected.
18