User manual

E09
o The appliance has recognised a foam surplus, therefore the wash
cycle completes without spinning.
9 To get the soap suds out of the clothes, the rinses and conditioning
program should be selected. Do not put any detergent in the
machine for this wash cycle.
Once the machine has been plugged back into your mains power
supply, to clear the fault code from the LCD display, you should turn
on the machine and hold down the Start/Stop button for approximately
5 seconds.
IF THE FAULT CODE REAPPEARS AFTER
FOLLOWING THE ABOVE ADVICE AND CLEARING
THE FAULT CODE. YOU SHOULD TURN THE WASH
PROGRAM SELECTION KNOB TO THE OFF
POSITION; DISCONNECT THE APPLIANCE FROM
YOUR MAINS SUPPLY. THEN ARRANGE FOR AN
ENGINEER TO ATTEND THE APPLIANCE. YOU
SHOULD CONTACT BAUMATIC SERVICE ON
TELEPHONE NUMBER [phone].
IF AN ENGINEER ATTENDS DURING THE
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED BY
THE CUSTOMER. THEN YOU MAY BE LIABLE FOR
THE COST OF THE SERVICE CALL.
24