Instruction manual

10
o There can be an odour when you first switch on the appliance. It
will lessen as the appliance starts to cool.
During first use
o When you first switch on the appliance, the compressor will run
continuously until the wine cooler reaches a cool enough
temperature.
o During this period of time, you should try not to open the door
frequently or place bottles inside of the appliance.
o If the unit is switched off or unplugged, you must allow at least 5
minutes before restarting the appliance or reconnecting it to
your mains supply.
Switching on the appliance and setting the temperature
o Press the ON/OFF button (R) to switch on the appliance.
o The temperature for each zone will need to be set individually.
o Use the temperature increase and temperature decrease buttons
to set the temperature that you require. Each press of these
buttons will adjust the temperature on the temperature displays
by one degree.
o Whilst you are setting the temperature of the cooling zone, the
relevant temperature display will flash. When you stop pressing
the temperature buttons, after a few seconds the display will
stop flashing and the temperature of the cooling zone will be set.
o For a few seconds, the temperature display will show the
temperature that you have set, before returning to show the
temperature that is currently being registered by the cooling
zone.
Changing between Fahrenheit and Celsius
o You can select whether the temperature displays show Celsius or
Fahrenheit. The Celsius/Fahrenheit temperature neons will light
to show whether Celsius or Fahrenheit is currently shown on the
temperature displays.
o To alter what the temperature displays are showing, press the
Celsius/Fahrenheit selector button (Q).
o You cannot change the display if you are in the process of
adjusting the temperature of a cooling zone.