Instruction manual

Reversing the door of your wine cooler
This appliance has the capability of the door opening from either the
left or right hand side.
The unit is delivered to you with the door opening from the left side. If
you want to reverse the opening direction of the door, please follow
the instructions below:
Any parts that you remove from the appliance whilst
reversing the door, should be retained for later use.
1) Carefully lay the wine cellar on its back. Use cushioning to protect
the floor and the rear of the appliance.
2) Whilst the door is shut, unscrew the two screws holding the bottom
hinge to the door and then remove the bottom hinge.
3) Carefully remove the door from the main body of the appliance.
4) Return the appliance to an upright position and then unscrew the
top hinge pin and cover, moving them to the opposite side of the
appliance.
5) Locate the new bottom hinge provided in the plastic bag inside the
wine cooler.
6) Place the door back onto the wine cooler, making sure that it lines
up with the top hinge pin.
7) Connect the new bottom hinge to the door and cabinet, you should
use the screws that you removed in step 2). These screws should be
fully tightened.
8) Keep the original bottom hinge in a safe place, in case that you wish
to reverse the door back to its original position.
IMPORTANT: Check that the door opens and shuts correctly,
without fouling, after you have completed the door reversal
process.
After the door has been reversed, you should check
the door seal of the wine cooler. The seal should be
creased or crushed; otherwise there will be a gap
between it and the inside of the door.
19