Operation Manual

o IMPORTANT: Do not use a silicon sealant to seal the appliance

against the aperture. This will make it difficult to remove the hob

from the aperture in future, particularly if it needs to be

serviced.

o Carefully turn the hob back over and then gently lower it into the

aperture hole that you have cut out.

o There are holes on the base or the sides of the hob that you can

fix the four brackets to. There are three holes in each one of the

brackets.

o You should place the

bracket on the

underneath of the

hob, in a position that

is appropriate for the

aperture that you

have cut out. Using

the screws provided,

fix the bracket to the

hob. These screws

MUST be securely

tightened.

Electrical connection

This appliance must be installed by a qualified

person in accordance with the latest edition of the

I.E.E. Regulations and in compliance with Baumatic’s

instructions.

Before connecting the appliance, make sure that the supply voltage

marked on the rating plate corresponds with your mains supply

voltage.

WARNING: THIS APPLIANCE MUST BE EARTHED.