User manual

28
Error codes
The following error codes may appear in the timer display if there is a
problem with the operation of the hob.
Error
code
Description Possible cause Solution
E2 Overheating of the
induction coils.
/ Cooling down
necessary.
ER03 &
permanent
tone
Permanent use of
keys; control unit
cuts off after 10
seconds.
Water or cooking
utensils on the
glass above the
control unit.
Cleaning of
the
operational
surface.
ER25 Secondary voltage of
the power unit too
high
(primary>300V).
Control unit switches
off after 1 second and
a permanent acoustic
signal is heard.
Control wrongly
connected.
Connect to
correct mains
voltage.
ER33 Water on the glass above the control
card.
Clean.
ER47 Communication error
between TC and
induction.
None or faulty
communication.
Ensure that
connection
cable is
plugged in
correctly.
U400 Secondary voltage of
the power unit too
high (primary.300V).
Control unit cuts off
after 1 second
releasing a
permanent tone.
Control unit is
wrongly
connected.
Connect to
correct mains
voltage.
“H” flashes Hot pan on the control card; faulty
radiant hotplate seal.
Wait until the
control card
returns to the
normal
temperature.
IMPORTANT: If any other error codes appear on the cooking
zone display, you should turn the appliance off at the mains
and contact the Service Department. DO NOT continue to use
the appliance.